Earthquakes can be weakened by groundwater

Induced earthquakes can be the result of activities like mining, gas and oil extraction, toxic waste or CO₂ storage, and the construction of tunnels and dam reservoirs. The generation of geothermal energy is another potential source of induced earthquakes -- and the main one in Switzerland. According to the Swiss Seismological Service, a geothermal project near Basel caused a 3.4 magnitude earthquake in 2006, and one in St. Gallen triggered a 3.5 magnitude trembler in 2013.

Geothermal energy is captured by tapping into subterranean heat. Highly pressurized water is pumped into the earth's crust at a depth of between two and four kilometers. The water is then recovered as steam and used to drive an electricity-producing turbine. "Injecting water can affect water-rock equilibria and disrupt nearby faults, thus triggering earthquakes in the area," says Marie Violay, who runs LEMR.

This type of earthquake is a thorn in the side of geothermal proponents, notes Mateo Acosta, a PhD student at LEMR and the study's lead author: "These earthquakes may be low in intensity, but they can cause damage and affect public opinion -- to the point of derailing projects."

Heat absorption

Acosta ran tests in which he sought to replicate earthquake conditions in order to study the impact of different levels of underground water pressure on fault dynamics. He focused mainly on earthquake propagation, which is when the two plates in a fault rub against each other, sending seismic waves out into the surrounding area.

"Rock friction generates a significant amount of heat, which further fuels the propagation effect," says the PhD student. "Some of this heat is absorbed by the water in the surrounding rock, and the amount absorbed depends to a large extent on the water's thermodynamic parameters. What we learned from our experiments is that the closer the fluid's initial pressure is to the critical pressure of water, the weaker the earthquake will be."

"This research shows that the initial fluid pressure in the rocks is crucial, especially at depths commonly reached by geothermal activities. Geothermal models need to take this into account," says François-Xavier Passelègue, an LEMR researcher and the study's second author.

The laboratory recently acquired sophisticated equipment that can be used to simulate pressure and temperature levels at a depth of 10 to 15 kilometers in the earth's crust. The researchers plan to use this equipment to more accurately measure the impact of groundwater on earthquake intensity.